Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You might locate that your garage door opener has actually been giving you issues, so you need to repair it. You can repair it by replacing a circuit card, a photo-eye sensing unit, the main drive equipment, or the set-limit switches. You can also inspect if the security sensing units are functioning effectively.

Changing a motherboard

Replacing a motherboard for your garage door opener calls for a couple of steps and also devices. First, you require to turn off the circuit breaker and separate any kind of cords. Next off, open up the motherboard cover. This will certainly assist you to diagnose the problem as well as identify if you need a brand-new board. Next, eliminate the old board and also its cord ports.

You can then continue to replace the circuit board. The substitute process is very easy as well as takes around 10 mins. A brand-new circuit card will cost regarding $80. To protect your new circuit card from power surges, you can buy a surge guard.

Replacing a photo-eye sensor

Replacing a photo-eye sensor can be a relatively straightforward task. First, remove the sensing unit from the door as well as ensure it is positioned correctly. If the sensor is angled in any way, it might not be receiving the right signal, which could be causing the strobe lights. If you discover that the photo-eyes are out of positioning, you might require to have a service technician come and also repair the problem.

The photo-eye sensing unit includes 2 pieces that place on the outside of the door tracks and also towards the flooring. The picture eyes will have a tiny LED light and need to be strong in shade. If the light is blinking, its likely the photo-eye is defective as well as will need to be replaced.

Replacing a major drive equipment

To replace a garage door opener main drive gear, beginning by removing the cap from the chain pulley. Next off, get rid of the two screws holding the drive gear to the gear assembly. Currently, you can loosen the three stress pins. Press them from both sides and after that remove them. After that, disconnect the 3 cables from the garage door opener motor. These cables must be white, red, and also blue.

When you have actually eliminated the old equipment, set up a new one. Be sure to oil it well. Place the new gear into the shaft, seeing to it to align the placing holes. Make certain the equipment and sprocket setting up are positioned appropriately to ensure smooth operation. Next off, utilize a hammer and also a nail to drive a pin right into the new equipment.

Readjusting the set-limit buttons

The initial thing you must do if your garage door is not working appropriately is to inspect the set-limit buttons. You might need to change them so that the door shuts earlier or quits before it gets to the flooring. You can examine this by checking out your garage doors manual or online.

To adjust the set-limit switches, youll require a screwdriver or socket. Adjust the handle clockwise or counterclockwise till the door moves up and also stops, or minimizes its range. To look for proper travel distance, determine the void from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Key St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *